Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 88)

4.2 Using the Digital Operator
88 YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual
◆ ALARM (ALM) LED Displays
Table 4.2 ALARM (ALM) LED Status and Contents
◆ LO/RE LED and RUN LED Indications
Table 4.3 LO/RE LED and RUN LED Indications
8
Function Key 2
(F1)
DATA Pressing scrolls to the next display.
→ Pressing scrolls the cursor to the right.
RESET Pressing resets the existing converter fault or error.
<1> Displayed when in DC Bus Voltage Reference Mode.
<2> Displayed when in DC Bus Voltage Reference Mode and Monitor Mode.
State Content Display
Illuminated When the converter detects a fault.
Flashing
• When an alarm occurs.
• When oPE is detected.
Off Normal operation (no fault or alarm).
LED Lit Flashing Off
<1> The indicator flashes in the following cases:
 When REMOTE operation is restored after inputting a Run command from an external terminal during LOCAL operation.
 A Run command was input from an external terminal in any mode other than Drive Mode.
 The STOP key on the digital operator was pressed during REMOTE operation.
When source of the Run command is
assigned to the digital operator
(LOCAL)
–
When a device other than the operator
is selected for Run command control
(REMOTE)
During run Stopped for an operation interlock. <1> During stop
Examples
No. Name Display Content
F1
F1
F1
RE
LO
RUN
TOEP_C710656_07C_2_0.book 88 ページ ２０１５年１月９日 金曜日 午後６時２３分