Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 57)

3.5 Terminal Cover
YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual 57
El
ec
tr
ical
I
n
st
al
lat
ion
3
3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ Models 2A0005 to 2A0020, 4A0005 to 4A0020 (IP20/Open Type Enclosure)
■ Removing the Terminal Cover
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by converter model.
Then, push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
Figure 3.17
Figure 3.17 Removing the Terminal Cover on an IP20/Open Type Enclosure Model
■ Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Circuit Terminal on
page 66 and Wiring the Control Circuit Terminal on page 79 for details on wiring.
Reattach the terminal cover after completing the wiring to the converter and other devices.
Figure 3.18
Figure 3.18 Reattaching the Terminal Cover on an IP20/Open Type Enclosure Model
<1> Connect ground wiring first, followed by the main circuit, and then wire the control circuit. Power lines and signal wiring
exit through the opening provided.
R1000
<1>
R1000
TOEP_C710656_07C_2_0.book 57 ページ ２０１５年１月９日 金曜日 午後６時２３分