C.1 memobus/modbus configuration – Yaskawa D1000 Series Power Regenerative Converter User Manual
Page 204
204
YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual
C.1 MEMOBUS/Modbus Configuration
C.1 MEMOBUS/Modbus Configuration
Converter can be controlled from a PLC or other master device via serial communications using the MEMOBUS/Modbus
protocol.
MEMOBUS/Modbus communications can be configured using one master (PLC) and up to 255 slaves. The converter
has slave functionality only, and serial communication is normally initiated from the master and responded to by the
slaves.
The master communicates with the specified slave converter. The address or node for each slave must be set prior so the
master can communicate with the slave at that address. A slave that receives a command from the master will perform the
specified function and send a response back to the master.
Figure C.1
Figure C.1 Connecting Multiple Converter to a PLC
Master (PLC or other)
Slave (converter)
D1000
TOEP_C710656_07C_2_0.book 204 ページ 2015年1月9日 金曜日 午後6時23分