Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 93)

4.3 The Drive and Programming Modes
YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual 93
S
ta
rt
-Up Pr
ogr
amming
&
O
p
er
at
io
n
4
◆ Switching Between LOCAL and REMOTE
LOCAL mode is when the converter is set to accept the Run command from the digital operator RUN key. REMOTE
mode is when the converter is set to accept the Run command from an external device.
Switch the operation between LOCAL and REMOTE using the key on the digital operator or via a digital input.
Note: 1. After selecting LOCAL, the LO/RE light will remain lit.
2. The converter will not allow the user to switch between LOCAL and REMOTE during run.
■ Using the LO/RE Key on the Digital Operator
■ Using Input Terminals S1 through S8 to Switch between LOCAL and REMOTE
It is possible to switch between LOCAL and REMOTE modes using one of the digital input terminals S1 through S8 (set
the corresponding parameter H1- to “1”).
Setting H1- to 1 disables the LO/RE key on the digital operator.
Step Display/Result
1 Turn on the power to the converter. The initial display appears.
2
Press . The LO/RE light will light up. The converter is now in LOCAL.
To set the converter for REMOTE operation, press the key again.
- MODE -
U1-51= 330V
U1-52= 330V
U1-53= 0.00A
DRV
Volt Ref (A1/A2)
Rdy
RSEQ
RREF
YAI
LO
RE
F2 F1
ESC
RUN STOP
ENTER RESET
ALM DIGITAL OPERATOR JVOP-180
- MODE -
U1-51= 330V
U1-52= 330V
U1-53= 0.00A
DRV Volt Ref (OPR) Rdy
LSEQ
LREF
YAI
TOEP_C710656_07C_2_0.book 93 ページ ２０１５年１月９日 金曜日 午後６時２３分