Toshiba H1 Series - Manual (Page 101)

TMP92CZ26A
92CZ26A-98
3.6.4 Setting Example
This section explains how to set the DMAC using an example.
(1) Transferring music data from internal RAM to I2S by DMA transfer
The 32 Kbytes of data stored in the internal RAM at addresses 2000H to 9FFFH shall be
transferred to FIFO-RAM via I2S. Each time an INTI2S request is asserted, 64 bytes (4
bytes x 16 times) shall be transferred to FIFO-RAM using DMAC channel 0. Since INTI2S
is an FIFO empty interrupt, the first data must be set in advance. Therefore, only the first
64 bytes shall be transferred by DMA soft start. After 32 Kbytes have been transferred, the
INTDMA0 interrupt routine shall be activated to prepare for the next processing.
(a) Main routine
No Instruction Comments
1 ldl (hdmas0),2000H ; Source address = 2000H
2 ldl (hdmad0),i2sbuf ; Destination address = i2sbuf
3 ldw (hdmaca0),16 ; Counter A = 16
4 ldw (hdmacb0),512 ; Counter B = 512 (32768/64)
5 ldb (hdmam0),0AH ; Transfer mode = source INC, 4 bytes
6 set 0,(hdmae) ; Enable DMA channel 0.
7 ld (dmar),01H ; Transfer the first 64 bytes by DMA soft start.
8 nop ;
9 ld (dma0v),i2s_vector ; INTI2S = DMA0
10 ld (intedma01),xxH ; INTDMA level = x
11 ldw (i2sctl0),xxxxH ; Set operation mode for I2S.
12 ldw (i2sctl1),xxxxH ; Start I2S transmission.
13 ei xx ; Enable CPU interrupts.
(b) INTDMA0 interrupt routine
No Instruction Comments
1 res 0,(hdmae) ; Disable DMA channel 0.
2 :
3 :
4 :
5 :
6
7
8
9
10
11 reti ;