Toshiba H1 Series - Manual (Page 337)

TMP92CZ26A
92CZ26A-334
b. Receiving
In SCLK Output Mode the synchronous clock is output on the SCLK0 pin and the
data is shifted to Receiving Buffer 1. This is initiated when the Receive Interrupt flag
INTES0<IRX0C> is cleared as the received data is read. When 8-bit data is received,
the data is transferred to Receiving Buffer 2 (SC0BUF) following the timing shown
below and INTES0<IRX0C> is set to 1 again, causing an INTRX0 interrupt to be
generated.
Setting SC0MOD0<RXE> to 1 initiates SCLK0 output.
Figure 3.14.15 Receiving operation in I/O Interface Mode (SCLK0 Output Mode)
In SCLK Input Mode the data is shifted to Receiving Buffer 1 when the SCLK input
goes active. The SCLK input goes active when the Receive Interrupt flag INTES0
<IRX0C> is cleared as the received data is read. When 8-bit data is received, the data
is shifted to Receiving Buffer 2 (SC0BUF) following the timing shown below and
INTES0 <IRX0C> is set to 1 again, causing an INTRX0 interrupt to be generated.
Figure 3.14.16 Receiving Operation in I/O interface Mode (SCLK0 Input Mode)
Note: The system must be put in the Receive Enable state (SC0MOD0<RXE> = 1) before data can be received.
SCLK0 output
(<SCLKS> = 0:
rising edge mode)
IRX0C
(INTRX0 interrupt
request)
RXD0 Bit0 Bit1 Bit6 Bit7
SCLK0 output
(<SCLKS> = 1:
falling edge mode)
SCLK0 input
(<SCLKS>
= 0:
rising edge mode)
SCLK0 input
(<SCLKS>
= 1:
falling edge mode)
IRX0C
(INTRX0 interrupt request)
RXD1 Bit1 Bit6 Bit7 Bit5 Bit