Toshiba H1 Series - Manual (Page 493)

TMP92CZ26A
92CZ26A-490
(3-1) SPIST (SPI Status Register)
SPIST shows 4 statuses.
SPIST Register
7 6 5 4 3 2 1 0
bit Symbol TEMP TEND REND
Read/Write R R
After reset 1 1 0
Function
Transmit FIFO
Status
0: no space
1: having
space
Transmit
Status
0: during
transmission
or having
transmission
data
1: finish
Receive
Status
0: during
receiving
or not having
receiving
data
1: finish or not
having space
15 14 13 12 11 10 9 8
bit Symbol
Read/Write
After reset
Function
Figure 3.17.9 SPIST Register
(a) <TEMP>
For UNIT transmission, it is cleared to “0” when valid data exists in transmit register
(SPITD). It is set to “1” when no valid data exists.
For Sequential transmission, it is set to “1” when no valid data exists in transmit buffer.
(b) <TEND>
This bit is cleared to “0” when valid data to transmit exists in the shift register/FIFO buffer
or when transmission. It is set to “1” when no valid data exists in the transmit data
register/FIFO buffer and finish transmitting all the data.
(c) <REND>
For UNIT receiving, it is set to “1” when finish receiving and valid data was loaded to
receive data register (when valid data exists). It is cleared to “0” when no valid data exists
in receive register (SPIRD). It is set to “1” when no valid data exists or during receiving.
For Sequential receiving, it is set to “1” when valid data of 32 bytes exist in receive FIFO
after finish receiving last data. It is cleared to “0” even if having space of 1byte.
RFUL flag does not exist because meaning is the same with REND flag.
SPIST
(824H)
(825H)