Toshiba H1 Series - Manual (Page 401)

TMP92CZ26A
92CZ26A-398
3.16.3.17 EOP Register
This register is used when a dataphase of control transfer type terminate or when a
short packet is transmitting of bulk-IN, interrupt-IN.
7 6 5 4 3 2 1 0
bit Symbol EP7_EOPB EP6_EOPB EP5_EOPB EP4_EOPB EP3_EOPB EP2_EOPB EP1_EOPB EP0_EOPB
Read/Write W W W W W W W W
After reset 1 1 1 1 1 1 1 1
Note: EOP<EP7_EOPB, EP6_EOPB, EP5_EOPB, EP4_EOPB> registers are not used at TMP92CZ26A.
In a dataphase of control transfer type, write “0” to <EP0_EOPB> when all
transmission data is written to the FIFO, or read all receiving data from the FIFO.
UDC is terminated status stage by this signal.
When short packet is transmitted by using bulk-IN or interrupt-IN endpoint, use
this for terminate writing transmission data. In this case, write “0” to <EP0_EOPB> of
writing endpoint. Write “1” to another bit.
EOP
(07CFH)