Toshiba H1 Series - Manual (Page 585)

TMP92CZ26A
92CZ26A-582
(10) PAGE register (for PAGE0/1)
7 6 5 4 3 2 1 0
Bit symbol INTENA ADJUST ENATMR ENAALM PAGE PAGER
(1327H)
Read/Write R/W W R/W R/W
After reset 0 Undefined Undefined Undefined
Read-modify
write
instruction
are
prohibited Function (Note)
Interrupt
1: Enable
0: Disable
“0” is read.
1: Adjust
TIMER
1: Enable
0: Disable
ALARM
1: Enable
0: Disable
“0” is read. PAGE
selection
Note: Pleas keep the setting order below and don’t set same time.
(Set difference time to Clock/Alarm setting and interrupt setting)
(Example) Clock setting/Alarm setting
ld (pager), 0ch : Clock, Alarm enable
ld (pager), 8ch : Interrupt enable
0 Select Page0
PAGE
1 Select Page1
0 Don’t care
ADJUST
1 Adjust sec. counter.
When set this bit to “1” the sec. counter become
to “0” when the value of sec. counter is 0 – 29.
And in case that value of sec. counter is 30-59,
min. counter is carried and become sec.
counter to "0". Output Adjust signal during 1
cycle of f
SYS
. After being adjusted once, Adjust
is released automatically.
(PAGE0 only)
(11) Reset register (for PAGE0/1)
7 6 5 4 3 2 1 0
Bit symbol DIS1Hz DIS16Hz RSTTMR RSTALM RE3 RE2 RE1 RE0 RESTR
(1328H)
Read/Write W
After reset Undefined
Read-modify
write
instruction
are
prohibited Function
0: 1 Hz 0: 16 Hz
1:Clock
reset
1: Alarm
reset
Always write “0”
0 Unused
RSTALM
1 Reset alarm register
0 Unused
RSTTMR
1 Reset timer register
<DIS1HZ> <DIS1HZ>
(PAGER)
<ENAALM>
Source signal
1 1 1 Alarm
0 1 0 1Hz
1 0 0 16Hz
Others Output “0”