Toshiba H1 Series - Manual (Page 353)

TMP92CZ26A
92CZ26A-350
Serial Bus Interface Baud Rate Register 0
7 6 5 4 3 2 1 0
Bit symbol − I2SBI − − − − − −
Read/Write W R/W R R/W
After reset 0 0 1 1 1 1 1 0
SBIBR0
(1244H)
Prohibit
Read-modify
-write
Function Always
read “0”
IDLE2
0: Stop
1: Run
Always read as “1” Always
write “0”.
Serial Bus Interface Data Buffer Register
7 6 5 4 3 2 1 0
Bit symbol DB7 DB6 DB5 DB4 DB3 DB2 DB1 DB0 SBIDBR
(1241H) Read/Write R (received)/W (transfer)
Prohibit
Read-modify
-write
After reset
Undefined
Note1: When writing transmitted data, start from the MSB (bit 7).Receiving data is placed from LSB(bit0).
Note2: SBIDBR can’t be read the written data because of it has buffer for writing and buffer for reading
individually.Therefore Read modify write instruction (e.g.“BIT” instruction ) is prohibitted.
Note3:Written data to SBIDBR is cleared by INTSBI signal.
I
2
C Bus Address Register
7 6 5 4 3 2 1 0
Bit symbol SA6 SA5 SA4 SA3 SA2 SA1 SA0 ALS I2CAR
(1242H) Read/Write R/W
After reset 0 0 0 0 0 0 0 0 Prohibit
Read-modify
-write
Function Slave address selection for when device is operating as slave device Address
recognition
mode
specification
Address recognition mode specification
0 Slave address recognition
1 Non slave address recognition
Figure 3.15.7 Registers for the I
2
C bus mode
Operation during IDLE 2 mode
0 Stop
1 Operation