Toshiba H1 Series - Manual (Page 436)

TMP92CZ26A
92CZ26A-433
Stage change condition of control read transfer type
1. Receive SETUP token from host
• Start setup stage in UDC.
• Receive data in request normally and judge. And assert INT_SETUP
interrupt to external.
• Change data stage into the UDC.
2. Receive IN token from host
• CPU receive request from request register every INT_SETUP
interrupt.
• Judge request and access Setup Received register for inform that
recognized INT_SETUP interrupt to UDC.
• According to Device request, monitor EP0 bit of DATASET register,
and write data to FIFO.
• If UDC is set data of payload to FIFO or CPU set short packet
transfer in EOP register, EP0 bit of DATASET register is set.
• UDC transfers data that is set to FIFO to host by IN token interrupts.
• When CPU finish transaction, it writes “0” to EP0 bit of EOP register.
• Change status stage in UDC.
3. Receive OUT token from host.
• Return ACK to OUT token, and state change to IDLE in UDC.
• Assert INT_STATUS interrupt to external.
These changing conditions are shown in Figure 3.16.10.
Figure 3.16.10 The Control Flow in UDC (Control Read Transfer Type)
SETUP DATA0 ACK IN NAK DATA1 DATA0 DATA1
INT_SETUP
INT_ ENDPOINT0
INT_STATUS
REQUEST FLAG
DATASET register
BRD
BWR
bmRequestType register
bRequest register
wValue register
wIndex register
wLength register Setup Received register
EP0_FIFO (WR of payload)
EP0_FIFO (Rest data) EOP register
IN ACK IN ACK OUT ACK