Toshiba H1 Series - Manual (Page 292)

TMP92CZ26A
92CZ26A-289
In this mode a programmable square wave is generated by inverting the timer
output each time the 8-bit up counter (UC0) matches the value in one of the timer
registers TA0REG or TA1REG.
The value set in TA0REG must be smaller than the value set in TA1REG.
Although the up counter for TMRA1 (UC1) is not used in this mode,
TA01RUN<TA1RUN> should be set to 1 so that UC1 is set for counting.
Figure 3.12.21 shows a block diagram representing this mode.
Figure 3.12.21 Block Diagram of 8-Bit PPG Output Mode
If the TA0REG double buffer is enabled in this mode, the value of the register buffer
will be shifted into TA0REG each time TA1REG matches UC0.
Use of the double buffer facilitates the handling of low-duty waves (when duty is
varied).
Figure 3.12.22 Operation of Register Buffer
Note: The values that can be set in TAxREG renge from 01h to 00h (equivalent to 100h). If the maximum value 00h
is set , the match-detect signal goes active when the up-counter overfolws.
8-bit
up counter
(UC0)
Comparator Comparator
TA0IN
φT1
φT4
φT16
TA01MOD<TA0CLK1:0>
TA1FF
TA0REG
Register buffer TA1REG
TA01RUN<TA0RDE>
TA0REG-WR
TA01RUN<TA0RUN>
TA1OUT
TA1FFCR<TA1FFIE>
INTTA0
INTTA1
Shift trigger
Internal data bus
Selector
Inversion
Selector
Q
2
Q
1
Match with TA0REG
and up counter
Match with TA1REG
Q 3 Q 2
(Up counter = Q
1
) (Up counter = Q
2
)
Shift from register buffer
TA0REG (Register buffer)
write
TA0REG
(Value to be compared)
Register buffer