Toshiba H1 Series - Manual (Page 642)

TMP92CZ26A
92CZ26A-639
Figure 3.27.2 Example of Data Bus Occupancy Timing in Debug Mode
Figure 3.27.2 shows an example of data bus occupancy timing in debug mode. If the steal
program issues a wait request immediately before the DMA operation for the LCD (LCD
DMA operation 1) and HDMA (HDMA operation 1) are asserted, these operations must
wait until the steal program is finished before they can be performed. (LCD DMA is given a
higher priority than HDMA in bus arbitration. This means that bus requests is
sued for LCD DMA and HDMA while the steal program is running are processed in the
order of LCD and HDMA (LCD DMA operation 2 → HDMA operation 2) regardless of the
order in which they are issued. )
Taking the above into account, it is necessary to ensure that each LCD DMA or HDMA
operation is finished before the next LCD driver output is started.
In other words, to avoid abnormal operation in debug mode, the maximum duration of
HDMA operation time must be set so that it does not interfere with LCD DMA operation.
Alternatively, the LHSYNC period should be adjusted to accommodate a wait request by
the steal program (80 times of transmission for debug clock: LH_SYNCLK), although this
slightly reduces the LCD display quality.
LHSYNC
LCP0
LD-bus
LCD DMA operation 1
HDMA operation 1
(Worst case)
LCD DMA operation 2
Setup time 1
Setup time 2
HDMA operation 2
Steal operation
(Worst case)
1
2
3