Toshiba H1 Series - Manual (Page 42)

TMP92CZ26A
92CZ26A-39
c. STOP Mode
When STOP Mode is selected, all internal circuits stop, including the internal
oscillator.
After STOP Mode has been cleared system clock output starts when the warm-up
time has elapsed, in order to allow oscillation to stabilize.
Figure 3.3.10 illustrates the timing for clearance of the STOP Mode Halt state by an
interrupt.
Figure 3.3.10 Timing chart for STOP Mode Halt state cleared by interrupt
Table 3.3.5 Example of warming-up time after releasing STOP-mode
@f
OSCH
=10 MHz
SYSCR2<WUPTM1:0>
01 (2
8
) 10 (2
14
) 11 (2
16
)
25.6 us 1.6384 ms 6.5536 ms
Interrupt for
releasing Halt
Data Data
STOP
mode
Warm-up
time
X1
A0~A23
D0~D31
RD