Toshiba H1 Series - Manual (Page 623)

TMP92CZ26A
92CZ26A-620
3.25.1 SFR
7 6 5 4 3 2 1 0
bit symbol PCM_ON
−
WUTM1 WUTM0
Read/Write R/W W R/W R/W
After
system
reset
0 0 0 0
After hot
reset
Data
retained
−
Data
retained
Data
retained
Function
Power
Cut Mode
0: Disable
1: Enable
Always
write “0”
Always
read as “0”
Warm-up time
00: 29 (15.625 ms)
01: 210 (31.25 ms)
10: 211 (62.5 ms)
11: 212 (125 ms)
Note: After wake-up interruption, internal wake-up timer count setting register value:<WUTM1:0>, and after about
77us, external PWE terminal change from low level to high level. Additionally after more about 92us, internal
reset signal will be released. We recommend to confirm actual performance on final set, because the time to
be stable all voltage level and power supply circuit are difference characteristics every final set.
The following operations are affected by the setting of the <PCM_ON> bit.
PCM_ON
= 1
PCM_ON
= 0
External interrupt input
No interrupt
HOT_RESET signal assert
Interrupt
Operation after reset −
Startup depending on the AM1
and AM0 pins
Operation after hot reset
Startup from boot ROM regardless
of the AM1 and AM0 pins and
jump to internal RAM area.
−
Warm-up counter
A change in the PWE pin level is
used as a trigger to start counting
the low-frequency clock for
releasing HOT_RESET.
Counter stopped
PMCCTL
(02F0H)