Toshiba H1 Series - Manual (Page 602)

TMP92CZ26A
92CZ26A-599
AD Mode Control Register 4 (AD Monitor function control)
7 6 5 4 3 2 1 0
bit Symbol CMEN1 CMEN0 CMP1C CMP0C IRQEN1 IRQEN0 CMPINT1 CMPINT0
Read/Write R/W R/W R/W R R
After reset 0 0 0 0 0 0 0 0
Function AD Monitor
function1
0: Disable
1: Enable
AD Monitor
function0
0: Disable
1: Enable
Generation
condition of
AD monitor
function
interrupt 1
0: less than
1: Greater
than or Equal
Generation
condition of
AD monitor
function
interrupt 0
0: less than
1: Greater
than or Equal
AD monitor
function
interrupt 1
0: Disable
1: Enable
(Note)
AD monitor
function
interrupt 0
0: Disable
1: Enable
(Note)
Status of
AD monitor
function
interrupt 1
0: No
generation
1: Generation
Status of
AD monitor
function
interrupt 0
0: No
generation
1: Generation
Note: When AD monitor function interrupts generate, it is cleared automatically and it is set to
disable condition.
AD Mode Control Register 5 (AD Monitor function control)
7 6 5 4 3 2 1 0
bit Symbol CMCH2 CM1CH1 CM1CH0 CM0CH2 CM0CH1 CM0CH0
Read/Write R/W R/W
After reset 0 0 0 0 0 0
Function Select analog channel for AD monitor function 1
000: AIN0 100: AN4
001: AIN1 101: AN5
010: AIN2 110: Reserved
011: AN3 111: Reserved
Select analog channel for AD monitor function 0
000: AIN0 100: AN4
001: AIN1 101: AN5
010: AIN2 110: Reserved
011: AN3 111: Reserved
Note1: When converting AD in hard ware trigger by setting <HHTRGE> and <HTRGE>to “1”, set
PGFC<PG3F> to “1” (as ADTRG) in case of external TRG before enabling it. When using
an INTTBx0 of 16-bit timer, first set the <TSEL1:0> or <HTSEL1:0> bit to “00” when the
timer is not operating. Then, set the <HHTRGE> and <HTRGE> to “1” and enable trigger
operation. Finally, operate the timer so that AD conversion will be initiated at constant
intervals.
Note 2: When disabling an external trigger (
ADTRG
) for AD conversion, first clear the <HHTRGE> or
<HTRGE> bit to “0”, and clear the PGFC<PG3F> to “0”, thus configuring port G as a
general-purpose port.
Note 3: When starting AD by using external trigger (ADTRG), it can be started after enabling
(<HHTRGE>
= “1” or <HTRGE> = “1”) and 3 clock at f
SYS
was executed. AD is not started
when before that time.
Note 4: When chaging compare register value of AD Monitor function, change it after setting AD
Monitor function to disable(ADMOD4<CMEN1:0>=”0”).
Figure 3.23.5 AD Conversion Registers
ADMOD4
(12BCH)
ADMOD5
(12BDH)