Toshiba H1 Series - Manual (Page 52)

TMP92CZ26A
92CZ26A-49
(2) I/O register settings
Table 3.4.5 shows the I/O registers that are set by the boot program.
After the boot sequence, if execution moves to an application system program
without a reset being asserted, the settings of these I/O registers must be taken into
account. Also note that the registers in the CPU and the internal RAM remain in the
state after execution of the boot program.
Table 3.4.5 I/O Register Settings by Boot Program
Register Name Set Value Description
WDMOD 00H Watchdog timer not active
WDCR B1H Watchdog timer disabled
SYSCR0 70H High-frequency and low-frequency oscillators operating
SYSCR1 00H Clock gear = 1/1
SYSCR2 2CH Initial value
PLLCR0 00H PLL clock not used
PLLCR1 00H
or
60H
Normally PLL is disabled.
However, only in the case of booting via USB, PLL is
activated for USB.
INTEUSB 04H USB interrupt level setting
INTETC01 44H INTTC interrupt level setting
Note: The values to be set in the I/O registers for UART and USB are not described here. If these functions are
needed in a user program, set each I/O register as necessary.