Lenze DSD - Manual (Page 136)

7 Applications
7.10 Chain conveyor
136
Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.10.2.7 Angle of tilt
Application with a slope (slide)
For the angle of tilt, only a positive value (slope) can be entered. However, you can dimension an ap-
plication with a slope by specifying a negative speed. If the application is moving on a slope with a
negative speed, it goes backwards.
Procedure:
• Enter the value of the slope into the Angle of tilt input field.
• Enter the value with a negative sign into the Speed input field.
7.10.2.8 Velocity
7.10.2.9 Mass of the payload
Symbol Description
β Angle of tilt (gradient)
• The value can be entered in degrees or as a percentage.
Symbol Description
v Speed of the transport chain
• Value is entered in the Motion dimensioning step.
Symbol Description
m
L
Mass of payload
• Value is entered in the Motion dimensioning step.