Lenze DSD - Manual (Page 417)

Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
417
16 Auxiliary means
16.1 Auxiliary means integrated in the DSD
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
16.1.1.10 "Mass of belt" calculator

How to call the calculator:
• Via the ToolsSpecial auxiliary calculatorsBelt mass... command
• Via the icon in the input area.

Note!
For calculating the mass of the belt of an application, manufacturer data regarding the
belt used are required.
Belts can be specified by using a weight standardised with regard to specific width. Re-
lating to a width of 10 mm, e. g. the mass is given in g/m. For this type of specification,
the presetting "Mass with reference width" is to be selected.
If the mass is specified for fixed belt widths relative to the length, the presetting "Mass
with length reference" is to be selected instead.
Button Function
= Calculate result.
Close Close dialog box.
• Only available if the calculator is called via the menu bar.
Accept Accept calculated value for the parameter and close dialog box.
• Only available if the calculator is called via the input area.
Cancel Discard calculated value and close dialog box.
• Only available if the calculator is called via the input area.
Input field Meaning
Specification Selection of the reference (width reference or length reference).
Reference width Input parameters for the calculation
• When selecting the length reference, the input parameters Reference width and Belt
width are inapplicable.
Specific mass of belt
Length of the belt
Mass of belt
Number of belts (par-
allel)
Number of the parallel running belts with the same data.