Lenze DSD - Manual (Page 444)

18 Drive dimensioning messages
18.1 Applications
444
Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
18.1.10 Low-friction dancer required for tensile force setting range xxx
18.1.11 Value range for the reel diameter not plausible
18.1.12 Value range for the tensile force of the winder not plausible
Note!
The tensile force setting range xxx is defined by the dancer. For this purpose, select a low-friction dancer.
Check whether this condition is complied with.
Cause Effects Possible remedies
The tensile force setting range re-
sults from the entered values for the
tensile force.
Minimum tensile forces cannot be
reached or cannot be repeated.
• Carry out recommended meas-
ures.
Stop!
The value range entered for the reel diameter is not plausible.
The minimum value is greater than the maximum value.
With these values, dimensioning is not possible.
Cause Effects Possible remedies
Minimum value is greater than max-
imum value.
Calculations are not possible. Enter values correctly.
Stop!
The value range entered for the tensile force of the winder is not plausible.
The minimum value is greater than the maximum value.
With these values, dimensioning is not possible.
Cause Effects Possible remedies
Minimum value is greater than max-
imum value.
Calculations are not possible. Enter values correctly.