Lenze DSD - Manual (Page 250)

8 Motion design
8.2 MotionDesigner
250
Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2.7.2 "Line" tab: Motion profile
In this tab, you create or edit the line elements of a motion profile. Select an already created element
to edit it. Values are always entered positively.
Legend Description
Base values
• Entry of the speed.
• Grayed out input fields are deactivated. The values are calculated automatically.
Specification  Specification – basic values ( 257)
Distance  Distance / angle – basic values ( 258)
Angle
Time  Time – basic values ( 258)
Velocity  Velocity / final speed – basic values ( 259)
Final speed
Starting velocity  Starting velocity / starting speed – basic values ( 259)
Starting speed
Acceleration  Acceleration – basic values ( 259)
Buttons
Set as default Accept values in the Basic values area as specification.
Apply changes Change the highlighted element in the Graphic area according to the entered values.
The button is only active if an element is selected in the Graphic area.
Attach element Attach an element with the specified values to the motion profile in the right Graphic area.
• The button is only active if no element is selected in the Graphic area.