Lenze DSD - Manual (Page 275)

Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
275
8 Motion design
8.3 Predefined motion profile according to operating mode
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.3.5.8 Operating time
8.3.5.9 Brake at standstill
8.3.5.10 Controller inhibit at standstill
8.3.5.11 Acceleration time
8.3.5.12 Deceleration time
8.3.5.13 Cycle time
Parameter Description
t
on
The operating time corresponds to the load time of the drive.
• The designation of the operating mode is supplemented by the operating time, e. g. "S2-
60 min".
Parameter Description
Active • Yes
• The brake is active at standstill. If the brake is activated, the motor does not have to provide
a torque.
• No
• The brake is not active at standstill.
Parameter Description
Active • Yes
• The controller inhibit of the inverter is set. The thermal load of the inverter and motor is
reduced by this.
• No
• The controller inhibit of the inverter is not set.
Parameter Description
t
acc
Acceleration time required by the drive until the constant load condition is reached.
Parameter Description
t
dec
Deceleration time required by the drive until standstill.
Parameter Description
t The cycle time corresponds to the duration of the load phase.