Lenze DSD - Manual (Page 233)

Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
233
8 Motion design
8.2 MotionDesigner
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 Selection whether elements of the parameter may have linearly changeable values.
• Field activated: You can only enter one value. The element entered changes erratically between
the previous value and the input value.
• Field deactivated: You can enter two values. The entered element linearly changes between
these two values.
• No selection is possible for the "brake" and "controller inhibit" parameters, as these control sig-
nals can only have the states 1 or 0.
• Special features:
• Selection possible in the independent MotionDesigner.
• Selection possible in the application-dependent MotionDesigner if a motion profile created in
the independent MotionDesigner is loaded.
• In the case of a mass of the payload that can be linearly changed, the force resulting from the
mass alteration is not taken into consideration.
• In the case of an inertia that can be linearly changed, the torque resulting from the change in
inertia is not taken into consideration.
Please note:
Continuous or erratic changes of the mass during motion which have an impact on the torque are
not taken into consideration for the calculation in DSD.
 Creating a parameter profile: Principles ( 240)
 Default value for the parameter.
• The parameter is automatically created with this standard value.
• The entry of more line elements creates an individual parameter profile.
• The "brake" and "controller inhibit" parameters do not have a default value as these control sig-
nals can only have the states 1 or 0.
 Creating a parameter profile: Principles ( 240)
Legend Description