Lenze DSD - Manual (Page 406)

16 Auxiliary means
16.1 Auxiliary means integrated in the DSD
406
Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Button Function
+/- Switch over between negative and positive mass.
• A negative mass can, for instance, be a bore that has to be subtracted from the field.
= Display result.
Call up density table.
• In the density table, the specific weight of the most important materials is specified.
Accept value Add the calculated value of the field to the table.
Change value Apply changes to the field selected from the table.
Delete marking Delete the field selected from the table.
Delete table Delete all fields in the table
Close Close dialog box.
• Only available if the calculator is called via the toolbar or the menu bar.
Accept Accept calculated value for the parameter and close dialog box.
• Only available if the calculator is called via the input area.
Cancel Discard calculated value and close dialog box.
• Only available if the calculator is called via the input area.
Input field Meaning
Field Selection of the field to be calculated.
• If "Direct entry" is selected, the mass value of the field in entered directly.
Designation Name of the field
• Optional input for easier identification of the individual fields.
Diameter, length,
density, radius, etc.
Input parameters for the calculation
• The input parameters depend on the field selected.