Lenze DSD - Manual (Page 55)

Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
55
6 Drive dimensioning tools
6.1 Data collection via checklists
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Drive dimensioning tools
6.1 Data collection via checklists
The parameters of the application are important data without which a dimensioning process can-
not be carried out. These parameters are marked in the check list with "*".
• The relevant data (e.g. mass, speed and motion) must be fully available.
• If less important data are missing (e. g. travelling resistances), you can make assumptions. Ad-
ditionally document this in the dimensioning protocol.
To support the data collection, the DSD contains a checklist for each application, by means of which
you can collect the data of the application.
• The checklists can be printed.
• The checklists are accessed via the ToolsApplication checklist menu.
• A dialog box opens, by means of which you can select the appropriate application via option
fields.
• By clicking on Open the corresponding checklist is opened in Word.
• The checklist contains queries concerning the following topics:

Tip!
The data marked with "Optional" are included in the checklist for the sake of completeness,
however, they are not absolutely required for the dimensioning.
Dimensioning part Data
Customers and project data Authorised user, customer, project.
Application data General drive; general drive with an import function for application data; ro-
tary table; travelling drive; belt conveyor for unit loads; belt conveyor for
bulk material; hoists with and without counterweight; chain conveyor; line
drive with single roll or squeegees; pump; fan; linear axes with a stationary
belt drive or an omega belt drive that is moved along; roller conveyor; spin-
dle drive; rack drive.
Motion • Operation with predefined motion profile according to operating mode
S1, S2, S3 or S6
• Operation with specific motion profile. The motion profile can be created
graphically or be imported.
• Collect the parameters in tabular form in the check list or make a
sketch.
Electrical supply and ambient condi-
tions
Optional
Miscellaneous Optional (accuracies...)
Motor Optional including third-party motor
Gearbox/ratio Optionally also for " Additional drive element"
Mechanical brake Optional
Inverters Optional
Dissipation of generated power Optional
Feedback Optional