Lenze DSD - Manual (Page 240)

8 Motion design
8.2 MotionDesigner
240
Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2.6.2 Creating a parameter profile: Principles
• Before creating or revising, select the corresponding parameter in the Object area. 
• Parameter profiles may only consist of line elements or imported elements. 
• Elements must be connected to each other. They must not overlap. 
• Disconnected elements are connected automatically.
• The y-value of the automatic connectors corresponds to the specification under the Line tab
in the Parameter area: Description .
• The automatic connectors are indicated as thin lines.