Lenze DSD - Manual (Page 442)

18 Drive dimensioning messages
18.1 Applications
442
Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
18.1.4 Speed of the application = 0 (standstill)
18.1.5 Safety check of controller inhibit failed
18.1.6 No values available for the torque of the application
Stop!
The speed of the application is xxx min -1 .
With this value, dimensioning is not possible.
Cause Effects Possible remedies
The velocity or speed entered is 0.
This is not a valid operating status for
the dimensioning.
This leads to subsequent conflicts if a
motor with a gearbox is selected, be-
cause the calculation of the trans-
mission ratio will involve a division
by zero.
If a motor without a gearbox is used
it is possible to continue, since only
the holding moment has to be de-
rived.
Enter a non-zero velocity value speed
value.
Warning!
Controller inhibit was activated although a torque from the drive is available.
Cause Effects Possible remedies
Brake has not been activated. • Drive is unguided with inhibited
controller.
• Drive moves in an uncontrolled
way.
Deactivate controller inhibit, or acti-
vate brake.
Stop!
The data imported or entered do not contain any values for the torque!
Without values, dimensioning is not possible.
Cause Effects Possible remedies
The application does not generate
any torque. If no torques or forces are
specified or imported and no frictions
or accelerations are specified for
masses or mass inertias, the calcula-
tion of the application torque results
in 0 Nm.
For this drive dimensioning, the DSD
needs the corresponding process pa-
rameters. Dimensioning without
these parameters is not possible.
Check entered values or imported
motion profile.