Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 151)

Rockwell Automation Publication 1426-UM001F-EN-P - November 2013 151
Chapter
7
Logic Functions
This section describes the functions of the PowerMonitor 5000 unit. Most
functions require you to configure set-up parameters to align the unit with your
installation and your application requirements. The set-up parameters are listed
by name and described in this section. You can view set-up parameters by using
the PowerMonitor 5000 web page, and when logged in to an Admin account,
make changes to the setup. Set-up parameters are also accessible by using
communication.
Please refer to the Data Tables for additional information on setup parameters
including the following:
• Range of valid values
• Default values
• Data type
Set-up parameters can be found in data tables with names beginning with
‘Configuration’, for instance Configuration.Metering.Basic.
Relay and KYZ Outputs The PowerMonitor 5000 unit is equipped with three electromechanical Form C
relay outputs, typically used for control and annunciation, and one KYZ output
solid-state relay designed for low-power, long-life signaling operation. The KYZ
output’s typical use is to provide a pulse output proportional to energy
consumption to an external totalizer.
Applications
This applies to all models.
Topic Page
Relay and KYZ Outputs 151
Status Inputs 155
Setpoints 157