Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 192)

192 Rockwell Automation Publication 1426-UM001F-EN-P - November 2013
Chapter 9 Communication
Number of Elements
This is the number of elements being read. These are the values:
1 = Single element write
>1 = Multiple element write, number of elements to read including the
first element
Destination Element
Look up the PCCC address (in Appendix A) of the specific data table address to
read. If performing a multiple element read, this addresses the first element in the
array.
RSLogix 5000 Software – CIP Generic Messaging Setup
The following example demonstrates a message instruction to read or write a data
table in the PowerMonitor 5000 unit by using the CIP Generic message type.
This setup applies to ControlLogix and CompactLogix programmable logic
controllers.
Message Type
CIP Generic.
Service Type
These are the choices:
Get Attribute Single = Read message
Set Attribute Single = Write message