Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 194)

194 Rockwell Automation Publication 1426-UM001F-EN-P - November 2013
Chapter 9 Communication
Path
This field specifies the communication path from the controller to the power
monitor. Set-up the path as <Backplane (always 1), Slot of Ethernet Module, Port
(always 2 for Ethernet), power monitor IP Address>.
Communication Method
For CIP Generic messaging, this defaults to CIP.
RSLogix 500 Software - Message Setup by Using PLC-5 or SLC Typed
Read/Write
The following is an example of a message instruction to read or write single or
multiple elements in a PowerMonitor 5000 unit by using peer-to-peer PLC-5 or
SLC 500 Typed messages in RSLogix 500 software. This setup applies to SLC
and MicroLogix programmable logic controllers.
Read/Write
Select Read or Write.
Target Device
Select PLC5 or 500CPU as appropriate.
Local/Remote
Select Local.