ATEIS UAPg2 User Manual
Page 59
UAPG2 MANUAL
Version EN.24
59
Start a project (basics and generalities)
Generalities (software philosophy)
When you want to design a project:
After installing hardware (connection, powering etc.) see Connect PC to UAPG2 (page 68 ), you will
use UAPG2 software to:
1.
Design signal path
2.
Define paging
3.
Define control of the system (logic I/O, URC, RAC, Third party, monitor)
4.
Define monitoring (monitor window)
5.
Upload design into UAPG2 system see UAPG2 system connection (page 72)
To do so you have three different levels in the software:
1.
System Hardware definition (re-create your hardware in the software)
2.
Define UAPG2 (Define the signal path inside UAPG2)
3.
Define component (adjustments and also control of parameters)
Level 1 System Hardware definition
First you have to explain to the software which hardware you are using
Here you have two UAPG2s, three URCs and two PPMs
Level 2 Define UAPG2
Now you can enter into each UAPG2 to create design (signal path) just double-click on the UAPG2
icon you want to design. Then drag and drop components between input and output and connect
them as you need
Here we use three inputs with limiter-compressor and parametric equalizer
Those inputs are connected individually to outputs:
In C1
Out B1
In C2
Out B2
In C4
Out B3, B4 and D1
Level 3 Define components
After designing signal path it is time to tune, monitor or control system:
By double-clicking the desired component you open it and have the
following possibilities:
1.
Monitor some audio
2.
Adjust settings
3.
Assign control to various controllers, (logic I/O analog, URC,
Third party…)
Right click on the virtual parameter( Button,
fader, LED: see: 5) Assignation philosophy (choose which
adjustments will be piloted by what) page 65)