ATEIS UAPg2 - Manual (Page 68)

UAPG2 MANUAL
Version EN.24
68
How to…
In this section you will have quick access to learn in details how to exploit UAPG2 capabilities.
Please, except the first four sections, read the Start a project (basics and generalities)chapter
before this section in order to learn the basics.
Connect PC to UAPG2
Generalities
There are two types of connections with UAPG2 software:
•
Ethernet connection
•
UAPG2 system connection
Ethernet connection
This connection allows PC to discuss with UAPG2 (one or several UAPG2 in a network) once this
connection established you can:
•
Check version of UAPG2 system or remote device (PPM, URC)
•
Update UAPG2 system or remote device (PPM, URC)
•
Upload design file in UAPG2 system
•
Connect PC to UAPG2 to adjust parameters in live
Connect the device
Connect your computer to the Ethernet connector of the UAPG2 using a straight CAT5 cable.
You can also using an Ethernet HUB (router) to connect your computer to several UAPG2. And switch
on the UAPG2.
1) Define IP address
By default (factory settings) the address of the UAPG2 is 192.168.100.XYZ where XYZ is the specific
address of the device. First of all you have to be sure that your computer net card is set on this
network. Please refer to your network card user manual to set it. You can safely choose
192.168.100.1 as network address for your computer…
With windows XP © you can proceed as follow to change your network address (With windows VISTA
you should do similar steps).
Note: for the picture the computer is in French…
Click [Start] button choose “parameters”
“network connection”