Ricoh 2400L - Manual (Page 229)

Switch 03 - Automatic printing of reports
Digit Purpose
0
Transmission result report (memory transmission)
0: Off 1: On*
1 Do not change this setting.
2 Memory storage report 0: Off* 1: On
3 Polling reserve report (polling reception) 0: Off* 1: On
4 Polling result report (polling reception) 0: Off 1: On*
5
Transmission result report (immediate transmission)
0: Off 1: On*
6 Polling clear report 0: Off 1: On*
7 TCR 0: Off 1: On*
Switch 04 - Automatic printing of reports, Various
Digit Purpose
0 Confidential reception report 0: Off 1: On*
1 to 6 Do not change these settings
7
Inclusion of part of the image on the following reports: Transmission Result Report,
Memory Storage Report, Polling Clear Report, Communication Failure Report,
Transfer Result Report, Transmission Deadline Report, Polling Confirmation List
0: No
1: Yes*
Switch 05 - Various
Digit Purpose
0 Substitute reception 0: Off 1: On*
1 Memory reception if no RTI or CSI received 0: Possible 1: Not possible*
2, 3 Do not change these settings
4, 5
Restricted Access Digit 5 Digit 4 Setting Digit 5 Digit 4 Setting
0 0 Off* 0 1 On
1 X Do not use these settings.
6, 7
Energy Saver mode Digit 7 Digit 6 Setting
0 0 Heater off
0 1 Heater energy saver mode*
1 X Do not use these settings
Switch 06 Home position
Digit Purpose
0 Printing TTI 0: Off 1:On*
1 Do not change this setting
2 Closed network in transmission 0: Disabled* 1: Enabled
3 Do not change these settings.
4 Batch Transmission (Feature Expander required) 0: Off* 1: On
5 to 7 Do not change these settings.
HOW TO USE THIS MANUAL
12