Ricoh 2400L - Manual (Page 69)

5. If you wish to change the setting, press 4 on the ten keypad.
6. Finish: Yes and Function.
Operating the Machine with Restricted Access Switched On
If you have switched Restricted Access on, the display is as shown below when
the machine is in standby mode.
Before you can use the machine, you must enter your personal code that you
have already registered in the machine. See page 56 for how to store Personal
Codes.
READY 100% 10:00AM
PERSONAL CODE:t t t t
1. Enter your personal code.
Example: 7 3 6 2 from the ten keypad.
2. Press Yes. After a second, the normal standby display will appear, and you can
use the machine. If the normal standby display does not appear, you entered
a personal code that is not stored in the machine.
If you decide that you do not wish to use the machine now, you should return the
machine to Restricted Access standby mode. To do this, either:
❐ Insert a page into the document feeder and remove it immediately.
Press Function twice.
Tonal Signals
Some organizations offer you special services by telephone, which you can
access by transmitting Touch Tone or DTMF tones. If your phone service provides
only pulse dialing, or if you are calling over a digital network, the ability to
generate Tonal Signals will allow you to access these services.
First, dial the other party. When you are through to the other end, press the tone
dial key and enter the code number that is needed to access the required feature
at the other terminal.
You do not need to press the tone dial key if your machine is set up for dialing in
Tone Dial (DTMF) mode.
Before you can use this feature, you must program Quick Dial key 31 as the
Tone key.
TRANSMISSION ADVANCED FEATURES
60