Ricoh 2400L - Manual (Page 343)

Specifying Which Senders Messages to Lock in Memory
If you like to receive information from only select locations into memory lock, you
can program the RTI code or CSI code of those locations. A terminal sending an
incoming messages always identifies itself to your terminal. The identification
consists of an RTI or a CSI. When you specify the senders for memory lock, you
must program a list of these codes. Program the list by Function 81 called
"Special Terminal" (See page 149.)
Selecting Which Mesages to Lock in Memory
You have to select one of the following two things
F
Lock all messages from those specified terminals.
or
F
Lock all messages except those from specified terminals.
1. Function 6 2 2 2 2 6 3 and Yes.
At this time, you can print a User Pa-
rameter List if you press
j
and Start.
SETTING? Y/j
PRINT LIST j
2. Yes. KPAD/Y/j k
SWITCH 00 :0000 0000
3. The settings for switch 00 are now
shown on the bottom line of the display.
4. Press
k
until the settings for switch 09 are
shown.
KPAD/Y/j k
SWITCH 09 : 0000 0000
5. The setting that you need to change is
that for digit 0 (double underlined) and 1
(underlined).
Set one of the two as shown opposite.
When you want to lock incoming mes-
sages in memory from specified termi-
nals;
SWITCH 09 :0000 0001
If you lock all incoming messages ex-
cept those from specified terminals;
SWITCH 09 :0000 0011
6. Finish: Yes and Function.
ADV
ANC
E
D
FE
A
T
URES
ADVANCED FEATURES RECEPTION
127