Ricoh 2400L - Manual (Page 355)

Switching Forwarding On/Off
Before you use Forwarding, you have to switch it on using Function 62. If it is
switched off, the machine will not forward any incoming fax messages.
After you switch Forwading on, ( F ORWARD) is displayed on the operation panel
when the machine is in standby mode.
Note: Forwarding cannot be switched on if Memory Lock is switched on. If you
wish to use Forwarding, you must switch Memory Lock off.
1. Function 6 2 2 2 2 6 2 and Yes. Y/NEXTk
SELECT LINE
2. Scroll through the list of features with
k
until the screen is as shown as opposite.
Y/NEXTk
FORWARDING ON/OFF
3. Yes. FORWARDING Y/j k
ON k OFF
4. Change the on/off setting by pressing
j
or
k
.
5. Finish: Yes and Function
Enabling and Disabling the Forwarding Mark
The forwarding mark is printed at the receiving end on the top of each page of the
fax messages that are forwarded from your machine. This mark will help the
operator at the other end to recognize messages that have been forwarded. If you
wish, you can switch this mark off.
To switch the Forwarding Mark on or off, do the following procedure. (See page 11
if you need more information about the User Parameter settings adjustment
procedure).
1. Function 6 2 2 2 2 6 3 and Yes. SETTING? Y/j
PRINT LISTj
2. Yes.
The settings for switch 00 are now
shown on the bottom line of the display.
KPAD/Y/j k
SWITCH 00 : 0000 0000
3. Press
k
until the settings for switch 02 are
shown.
The setting that you need to change is
digit 0.
SWITCH02 : 0000 0000
Digit 0 (Double Underlined)
0: Forwarding Mark is Off
1: Forwarding Mark is On
ADV
ANCED
FEA
T
UR
E
S
ADVANCED FEATURES RECEPTION
139