Ricoh 2400L - Manual (Page 500)

TRANSMISSION
Transfer Request
Transfer Request helps you save costs when you send the same message to
more than one place in a distant area. You send your message once, to a
machine referred to as a Transfer Station. In turn, this machine sends on the
message to local machines (referred to as End Receivers). After the Transfer
Station has broadcasted the message to all End Receivers in the sequence, it
sends your machine a Transfer Result Report to tell you if these were any
problems with the communication.
NOTE: ❐ This feature can only be used if the Transfer Station was made by the
same maker as your machine.
❐ The ID Code of your machine must be the same as the ID Code of the
Transfer Station.
❐ Your fax machine’s telephone number must have been programmed in
advance.
❐ The Transfer Station must have memory space available, and must be
able to act as a Transfer Station (some machines cannot do this, or
can but the capability has been switched off).
You cannot specify the End Receivers as full numbers on your ten-key pad, and
you cannot use your own stored Speed Dials, Quick Dials, and Groups. You must
use the numbers that are stored as Quick Dials, Speed Dials or Groups in the
Transfer Station. Always keep a copy of the Transfer Station’s Telephone Lists
(Quick Dial, Speed Dial, and Group Lists) near the machine if you plan to use
Transfer Request.
NOTE: This machine cannot be a Transfer Station.
Cross-reference
Quick Dial and Speed Dial: see pages 193.
Groups: see page 194.
ID Code: see page 46.
ADVANCED FEATURES
44