Ricoh 2400L - Manual (Page 869)

DISPLAYED ERROR MESSAGES
The following messages may appear while you are operating or programming
the machine.


 


You cannot use the auto-dialer at the moment. Use the
ten-key pad or the handset.
 
  
No polling reception operations have been programmed.
There are no messages in memory waiting for transmission.
There are no messages in memory waiting to be polled.
Incorrect file number. Check the file number and try again.
  
The memory cannot hold any more telephone numbers.
Either: Delete some numbers then try again.
Or: Wait until some of the Send Later or other delayed
transmissions waiting in memory have been carried out, then
try again.
    This Quick Dial Key has a Group stored in it.
    This Quick Dial Key has a Keystroke Program stored in it.
  
This Quick Dial Key has a telephone number stored in it.
  
 This Quick Dial Key has a Auto Document.
     This Quick Dial Key is programmed as Group Key.
   
Either:
This Quick Dial Key or Speed Dial Code does not contain a
number.
This Quick Dial Key does not contain a Keystroke Program.

   
Either:
This number is already included in this Group.
This RTI/CSI has already been stored for use with this feature.

  
You must add a pause after your area code when you input
your fax terminal’s own telephone number.
   The toner cartridge is empty. Install a new cartridge.


   
A document is jammed in the feeder.



 Paper is jammed in the printer.



 A cover is not closed properly. Check that all covers are closed.

   
Machine cannot print a list/file, because the heater is not
warm enough or plotter is not ready.



 Machine is out of order. Contact your service representative.
   No tonor cartridge. Install cartridge.
    The toner cartridge is near empty.
  
 
Dial Option feature is set in Quick 29.
DISPLAYED ERROR MESSAGES SOLVING PROBLEMS
178