Ricoh 2400L - Manual (Page 584)

The following pages explain the symbols that appear in certain columns of the
reports.
The Mode Column
See the bottom of the TCR for a full listening of the symbols that are used on the
TCR.
The Result Column
OK: Successful Communication
E: An error occurred
The Footnote on the TCR
TX counter: Total number of transmitted pages
RX counter: Total number of received pages
Counters listed on the User Parameter List
SCN: Total number of pages scanned
PRN: Total number of pages printed
Transmission Result Report (Memory Transmission)
In the Result column, some reports may have an "E" followed by a code, and
there may be a message printed at the bottom of the report. This code and
message indicate that a problem occurred. The codes are explained below.
RESULT MESSAGE EXPLANATION
1
HANG UP OR LINE FAIL The other party either a) hung up, b) had no
message on polling standby, c) cannot do
confidential reception or transfer request, or d)
had an ID Code that did not match the one in
your machine. Alternatively, there could have
been a problem with the telephone line.
2 BUSY The machine at the other end was busy.
3 NO ANSWER The line is dead (no dial tone was detected).
4 NO FACSIMILE CONNECTION There is no facsimile machine at the other end.
AUTOMATICALLY PRINTED REPORTS REPORTS
128