Ricoh 2400L - Manual (Page 370)

Note:If you see ALREADY INPUT,you already have a message on Free Polling
Standby.
F
To clear the old message: Clear the old polling transmission file
by function 23. ( See page 159 .) And start from the step 1 again.
Secured Polling
1. Place your document in the feeder. TRANSMIT OPTION k
DIAL FAX NUMBER
2. Function 1 4 and Yes. POLLING TRANS OPT k
PUSH START
NOTE
If you have not yet stored an ID Code using Function 61, you will be asked to
enter an ID Code. Proceed in the same way as for step 4 in "Stored ID
Override" on the next page.
3. Start
-Your fax message is stored and held on polling
standby.
Note:If you see AL READY I NPUT you already have a message on Secured
Polling Standby.
F
To erase the old message: Clear the old polling transmission file
by function 23. ( See page 159 .)
F
To keep the old message: Input an ID code in the same way as
for step 3 in "Stored ID Override" below.
Stored ID Override
This procedure will override the ID Code stored in your machine. The override is
only effective for this one transmission.
1. Place your document in the feeder. TRANSMIT OPTION k
DIAL FAX NUMBER
2. Function 1 4 and Yes. POLLING TRANS OPT k
PUSH START
3. Press
k
until the screen is as shown op-
posite.
SET OPTION Y/k
SET POLLING ID?
OTHER ADVANCED FEATURES
154