Ricoh 2400L - Manual (Page 614)

COMMUNICATION PROBLEMS
If " ERROR PRESS STOP KEY " appears in the display:
Press Stop.
❐ A poor line caused the communication to fail.
❐ The line is busy or noisy. Try to retransmit.
❐ The other machine is out of order.
❐ Ask the other party to check their machine.
OPERATING DIFFICULTIES
Problem Required Action
STANDBY MODE
Nothing happens when the
power switch is turned on.
Check the power cord. Is it properly plugged into the outlet?
➡ Plug it in firmly.
SET DOC. OR DIAL NO is
not displayed.
Switch the power on.
➡ If the Power indicator does not light, check
that the power cord is plugged in.
The display does not show
the Ready condition, or the
machine stops during an
operation. Does CLEAR ORIGINAL or CLEAR COPY appear in the
display ?
➡ Clear the misfed paper.
See pages 150 and 152.
Does ADD PAPER appear in the display?
➡ Load paper into the paper tray. See page 132.
Does CLOSE COVER appear in the display?
➡ Close all covers.
Is the Add Toner indicator on?
➡ Load a new toner cartridge. See page 133.
TRANSMISSION
The original is not pulled into
the auto docment feeder.
You did not feed the document far enough into the feeder.
➡ Insert the document into the feeder until it stops.
Retransmit.
Do user maintenance, especially rollers [A] and [F] (see page
139).
➡ If the same problem still exists after user
maintenance, adjust the auto document feeder
mechanism (see page 151).
The telephone line is disconnected.
➡ Check that the line is connected properly.
The telephone line type setting is incorrect.
➡ Check the telephone line type setting
(see page 192).
The dialed number does not contain an access code or a
pause.
➡ Include the access number and a pause before
the telephone number.
The dialed number did not have enough pauses between the
access number and the telephone number.
➡ Try adding more pauses after the access code.
OPERATING DIFFICULTIES SOLVING PROBLEMS
158