Ricoh 2400L - Manual (Page 886)

CONNECTING THE MACHINE
CAUTION: Do not switch on until everything is connected properly.
Before using the machine, it must be connected to the telephone line correctly
(see below). When this has been done, plug in the power cable and switch the
machine on.
❐ Make sure that it is properly connected to the telephone line and the power
outlet, as shown above.
❐ Program the Telephone Line Type setting (use Function 62, see page 208). If
your telephone normally sends out tones(touch tone) when dialing, use the TT
setting; if it normally sends out pulses (rotary dial), use the DP setting. Also,
make sure that the switch on the handset is set up correctly.
IMPORTANT POINTS ABOUT POWER CONNECTION
❐ The supply from the wall outlet must not fluctuate more than 20 V either side
of 115 Vac.
❐ The power cord should not be laid in a place where it might trip somebody.
❐ Do not lay anything on the power cord.
❐ If you have to use an extension cord, make sure that it is capable of carrying
125V/15A, and that your facsimile terminal is the only piece of equipment
connected to that cord.
TEL
LINE
Phone Company’s
Jack
Main Power Switch
Power
Source
115 Vac.
60Hz
Handset
I
NST
A
LL
ING
THE
M
A
CHINE
APPENDIX CONNECTING THE MACHINE
195