Ricoh 2400L - Manual (Page 491)

2. Press Yes. The settings for switch 00 are
now shown on the bottom line of the dis-
play. The setting that you need to
change is that for digit 0.
SWITCH 00 : 0000 0000
Digit 0(Double underlined)
0: Verification stamp off
1: Verification stamp on
3. If you wish to change the setting, press 0
on the ten keypad.
4. Finish: Yes and Function.
Redialing
If a message was not transmitted successfully, that does not mean that you have
to enter the telephone number again. In many cases, the machine will redial the
destination automatically. Or, with the Redial key, you can redial with just a few
keystrokes.
Automatic Redialing
The machine will automatically redial the other party if any of the following
conditions occurred.
❐ The other party was busy.
❐ There was no reply from the other party.
❐ The message was rejected by the machine at the other end because of
excessive errors (in this case, redialing will only take place if Memory
Transmission was used).
Redialing is done 4 times at 5 minute intervals (for a memory transmission) or 2
times at 5 minute intervals (for an immediate transmission).
❐ The number of redials and the redial interval may be adjusted by a service
technician.
During redialing, the number being dialed is
displayed as shown on the right. 21255551234
DIALING
ROU
T
INE
OP
ERA
T
ION
ROUTINE OPERATION SENDING A FAX MESSAGE
35