Ricoh 2400L - Manual (Page 591)

REPLACING THE STAMP
When the mark made by the verification stamp becomes pale, replace the stamp
as described below.
1. Pull up the scanner.
2. Replace the stamp.
If tweezers are not available, you
may press the point of a pencil down
vertically into the stamp and remove
it by lifting straight up.
3. Close the operation panel.
CHANGING THE PAPER SIZE
Main Cassette and Optional Paper Feed Cassette
1. Slide out the cassette until it stops.
Then, with both, remove it by holding it
up and lifting it out at the same time.
NOTE: Pull it out horizontally.
2. Push down the paper until it clicks into
place.
3. Take out the paper.
4. Adjust the paper fences to the paper
size. To move a fence, pinch the top
lever in and slide the fence in or out
as shown. Make sure the positions of
the two side fences match the paper
size by checking them against the scale
printed on the bottom of the cassette.
The fences should be aligned so that
the inside edge of each fence is just
touching the line of the scale.
[Main Cassette]
LOOKING AFT
E
R
T
H
E
MA
CHINE
LOOKING AFTER THE MACHINE REPLACING THE STAMP
135