Ricoh 2400L - Manual (Page 397)

REPLACING PAPER
F
When the Add Paper indicator ( ) on the operation panel is lit, the
cassette is empty.
1. Slide the cassette all the way out, and place
it on a large flat surface.
CAUTION
To avoid dropping the cassette, hold it by
the front and side while pulling it out.
2. Bend the new stack of paper a few times.
3. Push down the metal plate on the base
of the cassette until it clicks.
Make sure the positions of the two side
fences match the paper size by check-
ing them against the scale printed on
the bottom of the paper cassette.
The fences should be aligned so that
the inside edge of each fence is just
touching the line of the scale.
To move a fence, pinch the top lever in
and slide the fence in or out as shown.
Adjust the position of the two side
fences to match the paper size.
4. Place the paper into the cassette in the di-
rection shown opposite, making sure it
fits under the metal corners at the front.
If there is space between the paper and
a fences, the paper will not be fed prop-
erly. To avoid this, carefully move in
each fence until it is flush with the paper.
Note: If you have the optional cassette and change
the paper size, adjust the position of the two side fences to the size of the paper.
Then set the appropreate size plate at the front of the optional cassette. (See page 30.)
NOTE:
F
Make sure that the paper fits the corners.
F
Do not fill up the cassette past the load limit marker.
5. Replace the cassette carefully.
LOOKING AFTER THE MACHINE
Load Limit
LOOKI
NG AFT
E
R
T
H
E MACHI
N
E
181