Ricoh 2400L - Manual (Page 892)

ATTACHING THE OPTIONAL HANDSET
1. Attach the handset stand to the bracket
by two screws. (A)
Then attach the bracket with stand to
the machine by two screws. (B)
2. To avoid slack wire hanging at the rear of
the machine, attach the cord clip.
1) Insert the cord into the clip about two
thirds down (see diagram).
2) Peel off the adhesive cover on the
cord clip.
3) Fix the cord clip to the handset
bracket as shown.
3. Plug the cable to "Tel" jack on rear side
of the machine.
Note: Depending on which handset
you have, install the cord as
shown.
INSTALLING THE OPTIONAL FEATURE EXPANDER
Switch off the power before you install the
optional feature expander.
1. Remove the cover on the left side of the
machine.
2. Insert the memory card with the printed
face up.
Make sure that the machine and card
contacts touch.
3. Replace the cover. Then switch on the
power.
(A)
(B)
I
NST
A
LL
ING
THE
M
A
CHINE
APPENDIX ATTACHING THE OPTIONAL HANDSET
201