Ricoh 2400L - Manual (Page 43)

Redialing
If a message was not transmitted successfully, that does not mean that you have
to enter the telephone number again. In many cases, the machine will redial the
destination automatically. Or, with the Redial key, you can redial with just a few
keystrokes.
Automatic Redialing
The machine will automatically redial the other party if any of the following
conditions occurred.
❐ The other party was busy.
❐ There was no reply from the other party.
❐ The message was rejected by the machine at the other end because of
excessive errors (in this case, redialing will only take place if Memory
Transmission was used).
Redialing is done 4 times at 5 minute intervals (for a memory transmission) or 2
times at 5 minute intervals (for an immediate transmission).
❐ The number of redials and the redial interval may be adjusted by a service
technician.
During redialing, the number being dialed is
displayed as shown on the right. 21255551234
DIALING
Using the Redial Key
The machine remembers the last telephone number that you input. If you have to
redial this number, just press the Redial key, then press the Start key.
This feature has the following uses.
❐ If the machine is waiting to redial the other party, you do not have to wait for the
redialing interval to expire.
Press the Redial key, then press the Start key.
❐ If you wish to send another message to the same address that you just sent
last time, you don’t have to dial the full number again.
Place the message in the feeder, then press the Redial key, then press the
Start key.
To send a fax using Redial, do the following:
1. Make sure that the machine is in standby mode (see page 18).
2. Place your document into the feeder.
3. Press Redial. REDIAL Y
n 01 XYZ CO. NEW YORK
4. Press Start.
SENDING A FAX MESSAGE ROUTINE OPERATION
34