Ricoh 2400L - Manual (Page 837)

REPLACING PAPER
❐ When the Add Paper indicator ( ) on
the operation panel is lit, the cassette is
empty.
1. Slide the cassette all the way out, and place
it on a large flat surface.
CAUTION:
To avoid dropping the cassette, hold it by
the front and side while pulling it out.
2. Bend the new stack of paper a few times.
3. Push down the metal plate on the base
of the cassette until it clicks.
Make sure the positions of the two side
fences match the paper size by check-
ing them against the scale printed on
the bottom of the paper cassette.
The fences should be aligned so that
the inside edge of each fence is just
touching the line of the scale.
To move a fence, pinch the top lever in
and slide the fence in or out as shown.
Adjust the position of the two side
fences to match the paper size.
4. Place the paper into the cassette in the di-
rection shown opposite, making sure it
fits under the metal corners at the front.
If there is space between the paper and
a fences, the paper will not be fed prop-
erly. To avoid this, carefully move in each
fence until it is flush with the paper.
Note: If you have the optional cassette and
change the paper size, adjust the po-
sition of the two side fences to the
size of the paper.
Then set the appropreate size plate
at the front of the optional cassette
(See page 197).
❐ Make sure that the paper fits the
corners.
LOOKING AFTER THE MACHINE
Optional Lower Cassette
146