Lenze E94AYCCA - Manual (Page 35)

EDS94AYCCA EN 5.0 - 06/2012
L
35
E94AYCCA communication manual (CANopen®)
Commissioning
Settings in the »Engineer«
6.3 Settings in the »Engineer«
Go to the Settings tab to ...
 set the node address ( C13350 / C14350 ).
 Setting the node address
( 33)
 select the procedure for automatic allocation of the COB-IDs in the »Engineer«.
 configure the CAN node as a master or slave ( C13352 / C14352 ).
 display the time that must elapse after mains power-up before the CAN NMT
master transmits the "Start remote node" telegram via the system bus (CANopen)
( C13378 / C14378 ).