Lenze E94AYCCA - Manual (Page 51)

EDS94AYCCA EN 5.0 - 06/2012
L
51
E94AYCCA communication manual (CANopen®)
Process data transfer
Synchronisation of PDOs via sync telegram
8.4.1 Parameter setting
Short overview: Parameters for synchronisation via sync telegram
Sync source
C01120 is used to select the source of the synchronisation signals. Basically, only one
source can synchronise the node.
Sync cycle time
Time with which the internal phase-locking loop (PLL) expects the synchronisation signals.
The time must be set in C01121 in accordance with the cycle of the synchronisation source
selected in C01120 .
Example: For the system bus (CANopen), the interval between two synchronisation signals
has been set to 2 ms. If the system bus (CANopen) is to be used as synchronisation source,
a sync cycle time of 2000 μs must be set in C01121 .
Parameter Information Lenze setting Assignment
Value Unit Sync
Master
Sync
Slave
C13367
C14367
CAN SYNC Rx identifier 128 z
C13368
C14368
CAN SYNC Tx identifier 128 z
C00369/1 CAN SYNC transmit cycle time 0 ms z
C01120 Sync source Off z
C01121 Sync cycle time 1000 μs z
C01122 Sync phase position 400 μs z
C01123 Sync tolerance 0 μs z
C01124 Sync-PLL increment 109 ns z
C01130 Sync application cycle 1000 μs z

Note!
For synchronisation via the system bus (CANopen), only integer multiples of
1000 μs should be set in C01121 .